Avery Weigh-Tronix XR 2000 User Manual

XR Series Installation Instructions 31
7.2 Configuration Parameters
7.2 Configuration Parameters
Use the instructions in ’Entering Configuration Mode’, section 7.1 to access and
change the following parameters.
7.2.1 Parameter 1.0: Daytime Brightness Level
7.2.2 Parameter 1.1: Nighttime Brightness Level
7.2.3 Parameter 1.2: Power-save Mode
7.2.4 Parameter 1.3: Mirror Display Mode
Value Description
0 = Low
1 = Med Low
2 = Med High
3 = High<
Set the brightness of the display for daytime viewing. The built-in light sensor
automatically detects daylight conditions and sets the display brightness to this level.
Value Description
0 = Low<
1 = Med Low
2 = Med High
3 = High
Set the brightness of the display for nighttime viewing. The built-in light sensor
automatically detects night conditions and sets the display brightness to this level.
Lowering the brightness level at night helps reduce nighttime glare and energy costs.
Passing headlights, spotlights, etc. will NOT activate the daytime brightness level.
Value Description
0 = OFF
1 = ON<
Automatically dims display brightness one level below the selected brightness level
(day or night, as applicable) if there is no activity on the scale for 10 minutes.
Brightness levels are restored when motion is detected on the scale. This feature
saves power and increases LED longevity.
Value Description
0 = OFF<
1 = Mirror
2 = Cycle
Mirror mode causes the display to reverse so it can be read from a vehicle’s rear or
sideview mirror. Select Cycle and the display cycles between normal and mirror
mode every five seconds.

Avery Weigh-Tronix XR 2000 Specifications

General

Brand	Avery Weigh-Tronix
Model	XR 2000
Category	Monitor
Language	English