- 29 -
SEARCHINGCH˖001
EXIT˖
Ż 089.75MHz
TV Function
Swap
Use the CH+ or CH- button to select SWAP, press the number buttons on the
remote control to input the channel number, then the TV channel will be swapped to
the selected channel.
Blue Screen
This function is only available when there is no input signal.
Use the button to turn the function ON, use the button to turn the function OFF.
Fine Tuning
Use the CH+ or CH-button to select Fine Tuning, then press the direction
button to fine tune the TV channel forward or backward from the current channel.
Auto Memory
Use the CH+ or CH-button to select Auto Memory, press the OK or button to
enter auto memory mode:
The process of searching TV channels will take a few minutes. The unit will search
from the lowest channel to the highest channel in the standard channel list.
During searching, press the direction button to stop and return to the TV setup
menu. When searching operations are completed, the unit will memorize the
searched channels by sequence and exit auto memory mode.
Use the CH+ or CH-button to select the desired channel from those in memory.
To Next Page