SEEK+ button once to fine tune the radio frequency
backward or forward under radio mode.
Semi-memorizing radio stations
If you like a radio station and want to store it for later listening, press the SET button
to memorize it. “SAVE 00” will be displayed on the display panel, “00” represents the
default station number.
There are two methods to organize the memorized stations:
x Use the CH+ or CH- button to adjust the channel number for your
preference, and then press the SET button again, the station will be memorized
with the coded station number.
x Press the SET button again, the station will be automatically memorized with the
default station number in sequence.
You can store radio stations from 0 to 19, total 20FM or 20AM radio stations. If no
buttons are pressed within 3 seconds of pressing the SET button first time, the
frequency will appear on the display panel again, and the station will not be stored.
Accessing memorized radio stations
x First use the number buttons on the remote control to input, then press the OK
button for confirmation to go to the selected radio station directly; Or without
pressing any button and wait a moment, it also goes to the selected radio station.
x Press the CH+ or CH-button to select the radio stations forward and
backward.
When selecting the stations, the “CH 00” will appear on the display panel, where the
“00” is the channel number of the stored radio station. After a few seconds, the “CH
00” disappears and the radio frequency will be displayed once again.
To Next Page
Loading...