WEAT C2 N - V1
every problem or external intervention.
This kit does not need any lubrication; you should check the condition of connections and the various electrical
cables and completely test the safety units (photo-electric cells, flashing light, obstacle stop, sensor bar, emer-
gency shutdown, etc.).
Check the condition of hinges for a leaf gate, wheels for a sliding gate and sliders for a garage door (lubricate
these parts if required)
REMINDER : DO NOT FORGET TO CUT THE 230 V POWER SUPPLY AND THE BATTERIES BEFORE ANY
PROCEDURE ON MOTOR UNITS or POWER SUPPLIES.
- To ensure the product performs at its best, it is essential that those who install the automated system comply
with current legislation and with safety regulations.
- Installation and cleaning must be documented (document to be completed on the next page).
This documentation must be kept by the user and made available to competent staff.
DOCUMENT TO BE COMPLETED WHEN MAINTAINING YOUR AUTOMATED SYSTEM
As previously stated, you must regularly check your automated system every 6 months at the most and note the
points checked and your comments.
This automated system must be checked and maintained by qualified and specialised individuals in com-
pliance with current standards in the country of use.
a – Cut off the electrical supply (disconnect the optional batteries) and then check the electrical cables, the
various connections and working parts. All worn or damaged parts must be replaced.
b – Re-connect the electrical supply and completely check safety elements.
Remote controls: Check the range of the remote control, change the battery if necessary.
Flashing light: Check that it is working properly, check its condition and that it is visible from the road.
Photo-electric cells: Check that it is working properly with the closing movement and is in good condition.
Optional sensor bar: Check that it is working properly, use a piece of wood to check it and check its
condition.
Optional emergency button: Check that it is working properly.
Obstacle stop: Place a 15kg weight in the passageway at the end of the stable door (use a bag of sand or buckets
of water for example); on closing, the gate must stop.
Lighting system of the clearance area around the gate: Check its condition and that it is working properly; if
necessary change the bulb.
To Next Page
Loading...
