Resetting to Factory Default Settings
If the device no longer functions as expected, you can choose to reset the device to its factory default
settings.
Use the firmware revert button to reset the device. The firmware revert button is shown in the following
diagram:
Figure 8: The firmware revert button below the SD card slot.
1. Ensure the camera is powered on.
2. Use the T10 star key to remove the SD cover.
3. Using a straightened paperclip or similar tool, gently press and hold the firmware revert button for two
seconds.
4. Re-install the SD cover.
CAUTION — Do not apply excessive force. Inserting the tool too far may damage the camera.
Resetting to Factory Default Settings 26
To Next Page
Loading...
Need help?
General
