Installation
Pre-Deployment In-Box Configuration
The camera comes equipped with an RJ45 connector that is accessible from the outside of the box for users
that want to configure camera settings before installing the camera. The RJ45 connector is accessible
through the small flap on the side of the camera box for easy configuration before unpacking the camera.
1. Locate and open the flap on the side of the camera packaging. Look for the Config label:
2. Connect a network cable to the RJ45 plug on the configuration cable. The network cable must provide
PoE power, IEEE 802.3af Class 3, to power the camera during configuration.
3. Connect to the camera using an ACC Client, the Camera Configuration Tool, or the camera's web
browser interface to configure the camera's settings. For more information about connecting to the
camera, see Assigning an IP Address on page16, and Accessing the Live VideoStream on page17.
4. Once you have finished making configuration changes, unplug the network cable.
Installation 6
To Next Page
Loading...
