Note: It is recommended that silicone sealant be applied around the edge of the junction box
to prevent moisture from entering the mounting surface.
6. Hook the camera onto the junction box using the mounting hooks, and let the camera hang.
Connecting Cables
Before connecting any cables, ensure that the cable connections are properly protected from moisture and
corrosion. Make sure the protective cable boot is installed over the Ethernet port to protect the connection
from dust and moisture.
1. If there are external input or output devices that need to be connected to the camera (for example:
door contacts, relays, etc.), connect the devices to the camera's digital I/O connector cables. For more
information see Connecting to Power and External Devices on page20.
2. If an external microphone and/or speakers need to be connected to the camera, connect the devices
to the camera's audio I/O cables. For more information, see Connecting to Power and External
Devices on page20.
3. Pull the cables through the wall or side conduit.
4. Put the piercing cap through on the ethernet cable and push it through the grommet.
Connecting Cables 11
To Next Page
Loading...
