(Optional) Enabling the Microphone
The H6A camera models feature an internal microphone, and include a switch to physically enable or disable
the microphone. The microphone switch is set to OFF by default.
It is recommended that you enable the microphone before installing the camera in its final location.
1. Locate the microphone switch on the camera assembly.
2. Slide the switch from the default OFFposition to ON to enable the microphone.
(Optional) Configuring the Microphone
You can configure the microphone or line-level audio input from the camera web interface or in the ACC
Client software.
l
In the camera web interface, the microphones are configured from the Microphone page. You can
adjust the microphone volume by changing the gain.
o
Line in Gain — configures the gain for the microphone that is built into the camera.
o
External Source Gain — configures the gain for any line level audio input that is connected to
the audio input connector on the I/O terminal block.
For more information, see the Camera Web Interface User Guide.
l
In the ACC Client software, the microphones are configured in the Microphone dialog box that can be
accessed from the camera's Setup tab. You can adjust the microphone volume by changing the gain
and link the audio to other cameras in the site.
o
External Input — configures the gain for any line level audio input that is connected to the
audio input connector on the I/O terminal block.
o
Internal Mic — configures the gain for the microphone that is built into the camera.
For more information, see the Avigilon Control Center Client User Guide.
(Optional) Configuring microSD Card Storage
To use the camera’s onboard storage feature, you must insert 1 microSD card into a microSD card slot. While
there are two microSD slots, currently the camera only supports a single microSD card in either slot for
(Optional) Enabling the Microphone 18
To Next Page
Loading...
