any mobile device using the following address:
http://camera.lan
For more information about configuring the camera from the mobile web interface see USB Wi-Fi Adapter
System User Guide.
Note: The camera will reserve the 10.11.22.32/28 subnet for internal use while the USB Wi-Fi Adapter
is plugged in.
Assigning an IP Address
The device automatically obtains an IP address when it is connected to a network.
Note: If the device cannot obtain an IP address from a DHCP server, it will use Zero Configuration
Networking (Zeroconf) to choose an IP address. When set using Zeroconf, the IP address is in the
169.254.0.0/16 subnet.
The IP address settings can be changed using one of the following methods:
l
The mobile web interface using the USB WiFi Adapter. For more information, see (Optional) Using the
USB Wi-Fi Adapter on the previous page.
l
Device's web browser interface: http://<camera IP address>/.
l
Network Video Management software application (for example, the Avigilon Control Center™
software).
l
ARP/Ping method. For more information, see Setting the IP Address Using the ARP/Ping Method
below.
Setting the IP Address Using the ARP/Ping Method
Note: The ARP/Ping Method will not work if the Disable setting static IP address through ARP/Ping
method checkbox is selected in the camera's device's web browser interface. For more information,
see the Avigilon IP Camera Web Interface User Guide.
Complete the following steps to configure the camera to use a specific IP address:
Assigning an IP Address 15
To Next Page
Loading...
