Avionaut GLIDER - 3.2 Installation

3.2 Installaon
A. Pull out the isox connectors as far out as possible. In order to pull the isox connectors out you
need to remove the plugs by moving the isox releasing mechanism (pic. 19). Push the isox
connectors fully into the Avionaut Glider seat base and then pull them as far out as possible unl
you can’t push them back into the base (pic. 20)
B. Place the Avionaut Glider onto a car seat so that the Avionaut Glider isox connectors face the
isox anchorage system between the seat and the backrest of the car seat (pic. 21). Click the
Avionaut Glider isox connectors into the isox anchorage system. When clicking in, the indicators
informing you about the correct installaon, should be green (pic. 22) and your Avionaut Glider
car seat can be easily aligned with the backrest of the car seat
D. Push the Avionaut Glider seat into the car seat so that the Avionaut Glider seat’s backrest is
aligned paralell with the backrest of the car seat (pic. 23)
E. Remove the plug of support leg (pic. 24) put the support leg into the hole in front of the Avionaut
seat base pressing the two catches in the leg so that they click in the two holes in the Avionaut
Glider seat base and pull the leg out so that it touches the oor (pic. 25)
The picture above shows the properly installed Avionaut Glider car seat using the isox system
with the support leg.
3.2
EN