Avionaut GLIDER - 5.1.3 Recline adjustment; 5.1.4 Check list; 5.1.5 Removing your child from the Avionaut Glider car seat

5.1.3 Recline adjustment
The Avionaut Glider’s recline angle can be adjusted to six dierent posions.
A. Pull the recline lever up. It is located under the front part of the seat. Depending on the need,
pull the seat forward or rearward (pic. 42)
B. When the seat is in the desired posion, release the lever and move the seat unl you hear a
clear clicking sound
C. Aer you adjust the seat to the desired recline posion always pull the Avionaut Glider car seat
to check if it has locked
5.1.4 Check list
In order to provide opmum safety to your child always check before you travel if:
• The Avionaut Glider car seat is stable and safely installed in the car
• The height of the harness’ shoulder belts is appropriate for your child
• Belts are not twisted
• An-slippery parts of the shoulder belt pads are laid at on child’s shoulders and breast cage
• The child is correctly fastened in the harness
• The child seat’s belts are not damaged (if they are, you must not use the Avionaut Glider car seat)
• Make sure the lap secon of a seat belt is routed low so the child’s pelvis is held ghtly
5.1.5 Removing your child from the Avionaut Glider car seat
A. Return the Avionaut Glider car seat to the sing posion (please also read: 5.1.3)
B. Press the red buon on the buckle to realese it (pic. 35)
C. Loosen the shoulder belts by pressing red buon on the adjuster and pull them as far forward
as possible (pic. 36) (do not pull the shoulder belt pads)
D. Pull the shoulder belts apart and remove the child from the Avionaut Glider car seat.
5.1.3
5.1.4
5.1.5
EN