The Setting Tab
The Setting tab allows you to set the following settings:
The Setting tab dialog box
Energy
Saving
Control
Check the Enable Energy Saver box and move the slider to
set the amount of time to start the energy saver after your
last action. The range is from 1 to 242 minutes. The default
value is 15 minutes.
Enable Power
Off
Check the Enable Power Off box and move the slider to set
the amount of time to automatically turn off the scanner after
your last action. The range is from 1 to 480 minutes. The
default is 242 minutes (4 hours). Note the value of “Power
Off” has to be greater than or equal to the value of “Energy
Saving”.
To Next Page
