10
© 2008 Directed Electronics. All rights reserved.
➤Status LED
Things to remember when positioning the Status LED:
It should be visible from both sides and the rear of the vehicle, if pos-•
sible.
It needs at least 1/2-inch clearance to the rear.•
It is easiest to remove a small panel, such as a switch blank or a dash •
bezel, before drilling a 9/32-inch hole.
Use quick-disconnects near the LED wires if the panel is removable. This lets •
mechanics or other installers remove the panel without cutting the wires.
To Next Page
Loading...