49
© 2008 Directed Electronics. All rights reserved.
2-11 FACTORY ALARM DISARM PULSES—SINGLE, DOUBLE: Selectable for a
single or double-pulse for the vehicle’s factory alarm disarm input requirements.
2-12 AUX 1 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30
SECOND TIMED OUTPUT: This wire provides a (-) 200mA output whenever
the transmitter button(s) controlling AUX 1 is pressed. This output can be pro-
grammed to provide the following types of outputs (see also the Feature Menus
section):
Validity: Output that will send a signal as long as the transmission is re-•
ceived.
Latched: Output that will send a signal when the Aux 1 button is pressed •
and will continue until the same button(s) is pressed again.
Latched, reset with ignition: Similar to the latched output, this type of output •
turns on the first time the Aux 1 button is pressed and turns off the next time
the same button is pressed. This type of output additionally stops and resets
whenever the ignition is turned on and then off.
30-second timed: Output that will send a continuous signal for 30 sec-•
onds.
Note: All auxilary channel timed outputs can be programmed using the Bit-
writer® (1-90 seconds).
2-13 Aux 1 LINKING (NONE)/ARM, DISARM, REMOTE START: When pro-
gramming to validity or timed output this can be programmed to activate when
arming or disarming (or remote starting) with the transmitter.
2-14 AUX 2 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SEC-
OND TIMED OUTPUT: AUX 2 can be programmed for these output configura-
tions. The unit is set to the default validity output. To change the configuration,
use the two-chirp setting to toggle through the different configurations. Refer to
feature 2-10 for additional detail.
2-15 AUX 2 LINKING (NONE)/ARM, DISARM, REMOTE START: Refer to fea-
ture 2-13 for additional detail.
2-16 AUX 3 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SEC-
OND TIMED OUTPUT: AUX 3 can be programmed for these output configura-
tions. The unit is set to the default validity output. To change the configuration,
use the two-chirp setting to toggle through the different configurations. Refer to
To Next Page
Loading...