Appendices 135
Boot configuration
To configure boot parameters:
1. Use the following command to configure the boot parameters of the console server. Refer to
Table B.2 for the description of parameters.
cli> config administration bootconfig [parameter] <value>
2. Activate and save your configuration.
CLI administration parameters
The administration section of the CLI interface is divided into three parts.
• Session management
• Backup configuration
• Firmware upgrade
Table B.2: CLI Boot Configuration Parameters
Parameter Value Description
boottype bootp | both | tftp To set the network boot type.
bootunit network To set from where the unit boots.
consolespeed 115200 | 19200 | 38400 | 4800 | 57600 | 9600 To configure the console speed.
ethernetip ethernetip | ethernetmode Assign a temporary IP address to the
Ethernet interface.
ethernetmode 100F | 100H | 10F | 10H | auto To set an Ethernet mode.
filename <filename> Add a filename of the image on the tftp server.
flashtest full | skip Enable or disable the Flash test.
maxevents <number> Set maximum number of Ethernet events
handled at once.
ramtest full | quick | skip Select a type of ram test.
tftpserver <n.n.n.n> Set the IP address of the tftpserver.
wdt off | on Enable or disable watch dog timer.
To Next Page
Loading...
