Chapter 6: Configuration Files 47
Port Interface Command
The Port Interface command specifies the physical interface for a port. If the RS-422 or RS-485
interface is specified, you may enable termination by including the Termination keyword. Omitting
the Termination keyword disables termination. See Physical interfaces on page 4 for
more information.
PORT <port>|ALL INTERFACE=[RS232|RS422|RS485] [TERMINATION]
Port Connection Method Commands
The port connection method commands enable or disable connection methods to the ESP-4 MI hub
serial ports. See Serial Port Connection Methods on page 11 for information about enabling
multiple connection methods.
Port Redirection command
The Port Redirection command enables or disables the port redirection connection method on a
serial port. See Table 3.1 on page 12 for parameter descriptions and rules for use.
PORT <port>|ALL REDIRECT ENABLE|DISABLE [BUFFERING=<hsec>]
Port Telnet Server command
The Port Telnet Server command enables or disables the Telnet server connection method on a
serial port. See Table 3.2 on page 13 for parameter descriptions and rules for use.
PORT <port>|ALL TELSERVER ENABLE|DISABLE
[LOCALIPPORT=<lport>] [TIMEOUT=sec>] [BUFFERING=<hsec>]
Port TCP Server command
The Port TCP Server command enables or disables the raw TCP server connection method on a
serial port. See Table 3.3 on page 14 for parameter descriptions and rules for use.
PORT <port>|ALL TCPSERVER ENABLE|DISABLE
[LOCALIPPORT=<lport>] [TIMEOUT=<sec>] [MONITORDCD ENABLE|DISABLE]
[BUFFERING=<hsec>] [IDLEBUFFERING ENABLE|DISABLE]
Port TCP Client command
The Port TCP Client command enables or disables the raw TCP client connection method on a
serial port. See Table 3.4 on page 15 for parameter descriptions and rules for use.
PORT <port>|ALL TCPCLIENT ENABLE|DISABLE
DESTIP=<dest_ip> [DESTPORT=<dest_port>] [LOCALPORT=<lport>]
[CONNECTMODE=AUTO|DATA|DCD] [TIMEOUT=<sec>] [BUFFERING=<hsec>]
[IDLEBUFFERING ENABLE|DISABLE]
To Next Page
Loading...
