EasyManua.ls Logo

Avocent SwitchView IP 1020 - Figure 3.7: Active Directory - KVM Appliance Admin

Avocent SwitchView IP 1020
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22 SwitchView IP 1020 Remote Access Device Installer/User Guide
Figure 3.7: Active Directory - KVM Appliance Admin
Group Attribute – A username, password and group query is made to the directory service for
an appliance and attached target devices when using Query Mode (Appliance), or for a selected
target device when using Query Mode (Target Device). If a group is found containing the user
and the appliance name, the user is given access to the appliance or attached target devices,
depending on the group contents, when using Query Mode (Appliance). If a group is found
containing the user and target device IDs, the user is given access to the selected target device
connected to the appliance when using Query Mode (Target Device).
Groups can be nested to a maximum of 16 levels in depth. Use nesting to create groups within
other groups. For example, you may have a top-level group named Computers that contains a
member named R&D, which is a group. The R&D group may contain a member named
Domestic, which is a group, and so on.
The following is an example of groups defined in Active Directory.

Table of Contents

Other manuals for Avocent SwitchView IP 1020

Related product manuals