EasyManua.ls Logo

Avocent SwitchView IP 1020 - Figure 3.4: LDAP Search Page in the OBWI

Avocent SwitchView IP 1020
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 SwitchView IP 1020 Remote Access Device Installer/User Guide
example, to define an administrator Distinguished Name (DN) for test.view.com, type
cn=Administrator, cn=Users, dc=test, dc=view, and dc=com. This Search DN field is a required
field unless the directory service has been configured to enable anonymous search, which is not the
default. Each Search DN value must be separated by a comma.
The Search Password field is used to authenticate the administrator or user specified in the Search
DN field.
Use the Search Base field to define a starting point from which LDAP searches begin. The
modifiable default values are dc=yourDomainName and dc=com. For example, to define a search
base for test.com, type
dc=test, dc=com. Each Search Base value must be separated by a comma.
The UID Mask field specifies the search criteria for User ID searches of LDAP target devices. The
format should be in the form <name>=<%1>. The default value is sAMAccountName=%1, which
is correct for use with Active Directory. This field is required for LDAP searches.
Figure 3.4: LDAP Search Page in the OBWI

Table of Contents

Other manuals for Avocent SwitchView IP 1020

Related product manuals