exhaust hose should be placed outside the window so that the hot air can be discharged indoors.
2. Press TEMP(+) or TEMP（-）to adjust the setting temperature, 17-30 ℃.
3. You can choose one of the high,middle or low wind speeds by pressing the wind speed key.
CAUTION:
To improve the refrigeration capacity of the machine, please note the following:
a）If the room is direct sunlight, please draw the curtains.
b）Don't put the machine in a place where there is heat.
Heating Operation
1. Press the mode key continuously until the heat-making lamp is lit.
2. Press "+" or "-" button to choose the temperature you want, the temperature range is 15℃-25℃.
3. Press the WIND key to select the appropriate speed position.
Dehumidify Operation
1. When using the machine, close the doors and windows to avoid excess water entering the room.
2. Press the MODE key. When the dehumidification indicator is on, dehumidification function is
chosen. In this mode, the wind speed is not adjustable.
3. In the selection of dehumidification mode, the exhaust hose is not required.
Water Full Alarm
When the tank is full, the water indicator is illuminated. After a few minutes the "E4" code will be
displayed on the display and the compressor will automatically stop running. At this point, you can
remove the plug from the drain, drain water through the drainage pipe. “The E4 "code will
automatically disappear and the machine resumes normal operation.
L.E.D. DISPLAY
The display screen displays the temperature currently set or timing time.
※ The display screen also displays the machine's fault code。
Note: The optional function is available for consumers to select. The manual shows full functionality.
Drainage Mode
Automatic evaporation and drainage of condensed water
The machine can automatically evaporate condensing water and drain out of the exhaust hose. In
the refrigeration mode, the machine does not need to connect the drain to drain water, please ensure
that the plug of the machine has been installed.
To Next Page
Loading...
