NOTE: Actual application may vary slightly from illustrations.
Installation Steps
Page 2 of 2
screw
washer
hood shield
hood insert
hood
square hole
DO NOT OVER TIGHTEN
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
© 2016 Lund International, Inc. All rights reserved.
Auto Ventshade
TM
, the Auto Ventshade
TM
logo and the AVS
TM
logo are trademarks of Lund International, Inc.
Lund International
800-241-7219 • Visit us at lundinternational.com
™
Close hood, and install bump ons at pre-cleaned loca-
tions on the painted hood surface.
Align pre-drilled holes in hood shield with holes in hood. Place
hood shield on hood.
Press (6) hood inserts into the (6) square holes. If
necessary use tape to hold them firmly in place.
Using a phillips screwdriver install (6) screws with (6)
washers at the locations noted in Step 3.
Adjust bumper stops as needed to ensure hood shield clears grille
and headlights.
6
7
3
4
5
To Next Page
Loading...
