10
8
Page 3 of 4
11
9
12 13
14
NOTE: Actual application may vary slightly from illustrations.
Installation Steps
4 Piece Set
Clean painted door frame and door post.
Hold visor in place and mark front flange
locations with masking tape.
Apply surface prep to shaded areas.
DO NOT APPLY TO PAINT.
(Perform task for both sides of vehicle)
CAUTION: Read surface prep warning
on page 1 before continuing.
Remove tape liner from front & rear flanges. Peel back
2” (5 cm) of tape liner from each end of top flange.
2”
5cm
Attach visor to door. Front flange attaches to
door post, top & rear flanges to painted surface.
Remove tape liner.
Apply pressure to tape flanges to secure.
Repeat Steps 8-14 for passenger
side rear visor.
To Next Page
Loading...
