3
1
Page 2 of 4
Installation Steps
4
2
5 6
7
Repeat Steps 1-7 for passenger side
front visor.
NOTE: Actual application may vary slightly from illustrations.
Clean painted door frame and mirror cap.
Hold visor in place and mark front and rear
flange locations with masking tape.
Apply surface prep to shaded areas.
DO NOT APPLY TO PAINT.
(Perform task for both sides of vehicle)
CAUTION: Read surface prep warning
on page 1 before continuing.
Remove tape liner from front & rear flanges. Peel back
2” (5 cm) of tape liner from each end of top flange.
Attach visor to door. Front flange attaches to
outside of mirror cap, top flange to painted
surface, and rear flange to door post.
Remove tape liner.
Apply pressure to tape flanges to secure.
To Next Page
Loading...
