2
1.3 Rear Panel
CONNECTOR / BUTTON DESCRIPTION
Reset Default This button is hidden in the pinhole. Press and hold the reset button until the
network camera rebooted. This will reset all parameters, including the IP address
to factory default settings.
Power Indicator When the camera is power-supplied, this indicator will be on as red.
Audio Output Support the connection to an audio device, such as a speaker, for voice
transmission of the remote side.
Audio Input Support the connection to an audio device, such as a microphone, for voice
transmission of the local side.
Video Output Connect to the video input connector of your monitor with a video cable (i.e. a RCA
cable with the BNC connector, or a coaxial cable for video output.
* The video cable is optional.
LAN Connect the camera to the network with the supplied RJ45 cable.
Power Connector Connect the DC 12V adapter for power supply.
Alarm Connector Support the connection to an alarm device with the supplied alarm cable for
function scalability.
USB Port Connect to the optional wireless dongle to have the wireless function, or USB flash
drive for video recording.
To Next Page
Loading...
