Avtech avn212 - Ethernet Connection; 3.1 Network Connection via LAN

6
3. ETHERNET CONNECTION
Before using this network camera, please follow the instructions below to finish the network
connection setting based on your installation environment:
 To configure the network settings, you must connect the camera to your PC by LAN. For
details, please refer to “3.1 Network Connection via LAN” at page 6.
 To configure the Ethernet connection, please refer to “3.2 Ethernet Configurations” at page
9.
 To configure the wireless network connection, please refer to “4. WIRELESS
CONNECTION” at page 13.
3.1 Network Connection via LAN
Step1: Connect this network camera and your PC via a RJ45 network cable, and make sure the
camera is powered on.
Step2: Set the PC’s IP address as “192.168.1.XXX” (1~255, except 10).
For Windows 2000 users:
a) Select “Start”  “Settings”  “Network and Dial-up Connections”.
b) Right-click on “Local Area Connection”, and select “Properties”.
c) In the “General” tab, select “Internet Protocol (TCP/IP)”, and select “Properties”.
d) In the “General” tab, select “Use the following IP address”, and set the IP address as described below.
Note: It’s recommended to note down the current settings first and then change as
instructed. It’s helpful when you need to restore the PC network settings for
connecting to Internet later.