Avtech Room Alert S Series - Settings

AVTECH Software, Inc. Page 12 AVTECH.com
Room Alert S Models (RA32S-DAP-RAS & RA12S-DAP-RAS)
Settings
Accessing Settings
To access your Room Alert’s settings:
1. Select Settings in the navigation bar to the left of your screen.
2. Next, enter your credentials in the Username and Password elds.
• If you did not save custom credentials to your Room Alert 32S or 12S already, enter
these default credentials:
○ Username: admin
○ Password: password
• Then select Click Here To Access Settings.
Navigating Settings
Settings has the following sub-tabs shown in the navigation bar to the left of your screen.
• Sensors
• Alarms
• Network
• Email
• SNMP
• Security
• Advanced
You may navigate to each of these sections by selecting the appropriate sub-tab. Settings
opens by default to the Sensor Settings page.
Saving Settings
To save a setting, click out of the eld you just modied and notice that a notication bar
appears at the top and bottom of the page.
This notication bar contains the following items:
• A list of Settings pages you have unsaved changes on.