Installation Guide
& User Manual
Version: RH-SP06-201708
Super Quiet Split Series
Under Cabinet Range Hoods
Models: RH-SP06 (30”, 36”)
6” High, 6” Top Vent, 1mm Thickness
STOP and read! Test before installing
1. Please unpack the range hood and accessories carefully.
2. Remove the baffle filters, check any dent or damage inside and outside.
3. If found any loosing parts, please remove them.
4. Place the range hood and the split blower unit on a flat stable surface; connect the
Unit Connection Cord from the range hood to the split blower unit’s connector
inside the top connection box.
5. Plug in 120V AC power source. Press the power button and the speed buttons to
turn on.
6. Check if any unusual metal touching noise, check the speed variation, and press the
Light button to check the lights.
7. Verify all functions per Section 9 RANGE HOOD OPERATIONS.
8. Refer to Section 10 TROUBLESHOOTING if any malfunction was found.
9. The baffle filter are stainless steel covered by white protective film,
please remove the film before using the range hood.
IMPORTANT: Read and save these instructions.
NOTICE:
Installer: Leave this guide with the homeowner
Homeowner: Keep this guide for future reference
To Next Page
General
