1.
Research, plan and prepare the optional accessories & tools.
Duct venting and accessories (NOT INCLUDED)
• If for new installation or your old range hood doesn’t have exhaust duct, prepare
to cut the openings through the bottom of the cabinet, wall, or top cabinet to
ceiling. Two of 6” aluminum round ducts are included. Refer to Section 5
VENTING METHODS for detail.
• Check the existing exhaust duct size. If not 6” round metal duct, try to
get the converter / reducer / adapter / elbow as shown in the pictures.
• The damper is included on the top vent of the split blower unit.
• Also prepare the cutting tools (jig saw or reciprocating saw), screw drivers or power drill, level,
measuring tape, knife, duct/foil tape, screws, marker/pencil, etc.
• 2 people are required for the installation.
To Next Page
Loading...
