Operation Cautions:
• Read and understand all instructions and warnings in this manual before operating the appliance.
• Always leave safety grills and filters in place. Without these components, operating blowers could catch
on to hair, fingers and loose clothing.
• NEVER dispose cigarette ashes, ignitable substances, or any foreign objects into blowers.
• NEVER leave cooking unattended. When frying, oil in the pan can easily overheat and catch fire. The
risk of self-combustion is higher when the oil has been used several times.
• NEVER cook on “open” flames under the range hood. Check deep-fryers during use: Superheated oil
may be flammable.
10. TROUBLESHOOTING
light does not operate after
installation
• Check if the range hood has been plugged in, make sure that all power has
been turned back ON, fused not blown and all electrical wiring are
properly connected.
• Swap out light assembly to working ones to deter-
mine whether it is
caused by defective bulbs. See Replacing the Light Bulbs on Page 14.
when the blower is on
• The range hood might not have been secured properly on to the cabinet or
wall.
weak
• Check that the duct sized used is at least 6” or 3-1/4 x 10”. Range hood
WILL NOT function efficiently with insufficient duct size. For example:
7” duct over 6” top vent and loosely secured.
• Check if duct is clogged or if damper unit (half-circular flapper) is not
installed correctly or opening properly. A tight mesh on a side wall cap
unit might also cause restriction to the air flow.
The lights work but the
blower is not spinning at
all, is stuck or is rattling
• The blower might be j
ammed or scraping the bottom due to shipping
damage.
• Disconnect the power cord, remove the fan grill and the fan blade, might
see the fan blade or/and motor is not in the proper position (offset from the
center). Try to fix/adjust it or please contact us immediately.
The hood is not venting out
properly
• Make sure the distance between the stove top and the bottom of the hood is
within recommended 27” and 30” in distance. *
height configurations, recommended height may not be applicable.
• Reduce the number of elbows and length of duct work. Check if all joints
are properly connected, sealed, and taped.
• Make sure the power is on high speed for heavy cooking.
To Next Page
Loading...
