TrueBrake Installation Manual v1.0 - November 2019
© Aeroxcraft Ltd 2019
AXC Logo is registered trademark of Aeroxcraft Ltd. Logitech the Logitech logo and other Logitech marks are owned by Logitech and may be
registered.
*Aeroxcraft Ltd will not be held responsible for any damage to your Logitech pedals or steering wheel.
Step 6 - Install TrueBrake
TrueBrake consists of three parts:
• Cylinder
• Buffer (choice of 2 sizes)
• Spring
There are two sizes of buffer cap supplied with
TrueBrake.
The two sizes determine the amount of pedal
movement before the pedal engages with the
polyurethane
buffer. The small buffer cap gives 3mm
more movement than the large buffer cap.
personally prefers using the small buffer
cap. This gives the pedal a little more travel before it
engages, more like a
sporty road car than a full-on
Assemble the three TrueBrake components into a
stack.
• Cylinder > Buffer > Spring
To Next Page
Loading...