Operation instructions | EOC 1-32 and EOC 2-32 | Ethernet over Coax Peer to Peer
28 2021-06-23 | Technical improvements, changes in design, printing- and other errors reserved.
5.10. Firmware Upgrade
Firmware version
The current version of the firmware can be found in the Information window (see 5.2 on page 19).
Download of the file
You can find firmware updates for download by entering the article in the search field on www.axing.com.
On the product page you will find the current firmware in the Downloads tab.
Download the file to your computer and unpack it.
Upgrade of the Firmware
Click on Upgrade in the navigation on the right.
Click Browse ... and select the upgrade file.
Click Start.
The firmware/the driver file is loaded into the EOC and the device is restarted.
The new firmware will be activated immediately after restarting the EOC.
5.11. Restoring the factory settings
Press the reset button R on the back of the device for a few seconds until the LEDs start flashing.
All configuration settings made are reset to the factory settings.
To Next Page
Loading...
Need help?
General
