46
AXIS 210/210A/211/211A - System Options
Plain Config - this function is for the advanced user with previous experience of
configuring Axis cameras. All parameters can be set and modified from this page. Help is
available via the links on the standard setup pages.
Resetting to the Factory Default Settings
To reset the cameras to the original factory default settings, go to the System Options >
Maintenance web page (as described in
Maintenance, on page 44) or use the Control
button on the underside of the camera (see page 7) as described below:
Using the Control Button
To reset the cameras to the factory default settings using the Control Button:
1. Disconnect the power adapter, or the network cable if using PoE
(AXIS 210A/AXIS 211/211A only).
2. Press and hold the Control button while reconnecting the power.
3. Keep the Control button pressed until the Status Indicator color changes to
amber (this may take up to 15 seconds).
4. Release the Control button.
5. When the Status Indicator changes to Green (which may take up to 1 minute), the
process is complete and the cameras has been reset. The unit will now have the
default IP address 192.168.0.90
To Next Page
Loading...
Need help?
General
