5
AXIS 210/210A/211/211A - Introduction
Introduction
This manual covers the following Axis Network Camera models:
• AXIS 210
• AXIS 210A
• AXIS 211
• AXIS 211A
All instructions and information in this manual are valid for all four models unless
otherwise stated.
Product features
The AXIS 210/210A/211/211A cameras are part of the latest generation of fully featured
Axis Network Cameras, and are all based on the AXIS ARTPEC-2 compression chip.
The most basic model of the four is the AXIS 210. The other models support further
features listed in the overview below. All models support the following features:
• Video streams from the camera available on the network as real-time, full frame
rate Motion JPEG and/or MPEG-4 video streams.
• Video Motion Detection - this can be used to trigger e.g. image uploads when
there is activity in the video image.
• Scheduled image uploads.
• IP address filtering and multilevel password protection.
• Alarm input and output, which can be connected to various external devices, e.g.
door sensors and alarm bells.
• Multiple video resolutions.
• Simultaneous access by up to 20 viewers when using Motion JPEG. If MPEG-4
multicast is used, the number of viewers is unlimited, but each viewer still needs a
separate MPEG-4 license. One license is included in the product, additional
licenses can be purchased separately.
• Privacy masking allows the concealment of parts of the image that should not be
viewable. Up to 3 areas can be configured as masked areas.
To Next Page
Loading...
Need help?
General
