43
AXIS 240Q - System Options
If using HTTPS enter the password if it has not already been set. To set the password again,
the AXIS 240Q must be reset to the factory default settings.
Network - UPnP™
The video server includes support for UPnP™ in Windows ME and Windows XP. UPnP™ is
enabled by default.
Note: UPnP™ must be installed on your workstation. To do this, open the Control Panel from the Start Menu and
select Add/Remove Programs. Select Add/Remove Windows Components and open the Networking Ser-
vices section. Click Details and then select UPnP™ as the service to add.
Bonjour
Your Axis network camera includes support for Bonjour. When enabled, the camera is
automatically detected by operating systems and clients that support this protocol.
Ports & Devices
I/O Ports - the pinout, interface support and the control and monitoring functions
provided by this connector are described in
Unit Connectors, on page 47.
RS232 - The COM port RS-232 on the AXIS 240Q supports several operational modes
listed on this page. For more information, please see
COM Ports RS-232 and RS-485, on
page 49.
RS485 - The COM ports on the AXIS 240Q supports several operational modes listed on
this page. For more information, please see
COM Ports RS-232 and RS-485, on page 49.
Maintenance
• Restart - The unit is restarted without changing any of the settings. Use this method if
the unit is not behaving as expected.
• Restore - The unit is restarted and most current settings are reset to factory default val-
ues. The settings that will not be reset are:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
•the subnet mask
• the system time
• Default - The default button should be used with caution. Pressing this will return all of
the video server's settings (including the IP address) to the factory default values.
Upgrade Server - See Upgrading the Firmware, on page 50.
To Next Page
Loading...
Need help?
General
