46
AXIS 240Q - System Options
Resetting to the Factory Default Settings
To reset the AXIS 240Q to the original default settings, go to the System Options >
Maintenance web page (as described in
Maintenance, on page 43), or use the control
button on the front panel, as described below:
Using the Control Button
1. Switch off the AXIS 240Q by
disconnecting power.
2. Press and hold the Control
button while you reconnect
power.
3. Keep the Control button
pressed until the Status
Indicator displays yellow (this
may take up to 15 seconds).
4. Release the Control button.
5. When the Status Indicator changes to Green (may take up to 1 minute), the
process is complete and the AXIS 240Q has been reset.
6. Re-install the AXIS 240Q, as described in the Installation Guide.
Control Button
Status Indicator
To Next Page
Loading...
