Care for Boats that are Moored
Due to gelcoat discoloration, osmosis (blistering) and algae growth, it is not
recommended that you leave your boat moored for long periods of time. If your boat will
be moored in fresh water or saltwater for extended periods of time, you should do the
following:
1) Haul-out and clean your boat regularly (every 14 to 21 days). Use soap, water
and plenty of elbow grease.
2) Apply wax after cleaning.
You should also check with your local Axis dealer about anti-fouling paint and other
products that can be applied to the hull bottom below the water line.
Engine/Drive Train
Engine
For information on engine service, maintenance and break-in period, please refer to your
engine owner’s manual. The Required Maintenance Schedule included in this manual
covers the minimum maintenance required for Indmar engine packages. The
Maintenance Worksheet included in this manual outlines safety checks, lubrication and
general service that should be performed at regular intervals. It is recommended that any
engine replacement parts used for maintenance or repair be supplied by an authorized
Axis dealer.
Figure 4-1. AR335 MPI Engine
Care and Maintenance
4-4
Chapter 4_11_Axis_ Chapter 4 doc.qxd 12/2/10 9:39 AM Page 4
To Next Page
Loading...
Need help?
General
