Axis AKA120 - Page 51

USER MANUAL 51
_________________________________________________________________________________________________________________
Operation sequence:
Press MENU key and choose thr pressing  T 
key.
The following options are displayed successively:
- thr oFF – deactivate the function,
- thr on – activate the function,
- thr Prn – check last threshold values (press
key several times),
- thr CFG – choose Relays socket mode:
IMPULS - Batching mode
SIGNAL – Indication mode.
Choose thr-on option using  T  key. The
following options for entering thresholds are
displayed:
- SEt-LO - set lower threshold value,
- SEt-HI - set upper threshold value,
- SEt-ZEr - set zero signalisation threshold.
Using  T  key select SEt-LO option.
Set lower threshold value using the following keys:
- digit increase,
- decimal point,
T - move to next digit,
MENU - finish.
Then select SEt-HI option and enter upper
threshold value.
Choosing out option will cause starting work with
signalisation of exceeding thresholds and zero.
To change Relays socket mode use thr CFG option.
Default option is Indication.
To leave the function, press MENU key and then
choose thr and thr oFF options.
g