Axis AX-902 - Page 12

12
Adding Contacts
The unit can save contact telephone numbers for quick access.
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Continuously press
SEL button until “ADD NUM” displays.
3. Press and hold
SEL button again.
4. Using the volume knob, enter the name of the contact. Press
SEL button to save each character en-
tered.
5. Enter the phone number. Press
SEL button to save each number entered.
6. Press and hold
SEL button to save entry
Finding Contacts
After adding contacts, you can use this feature to nd them.
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Continuously press
SEL button until “FIND NUM” displays.
3. Press and hold
SEL button again.
4. Using volume knob, select the name of the contact and press
to call.
Deleting Contacts
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Press
SEL button repeatedly until “FIND NUM” displays.
3. Press and hold
SEL button again.
4. Rotate
VOL knob until the name of the contact you want to delete displays.
5. Press and hold “
” for 2 seconds to delete contact.
How to Set Incoming Call Melody
1. Press and hold
(*) then press and hold SEL button for 2 seconds.
2. Press
SEL button repeatedly until “MELODY” displays.
3. Rotate
VOL knob to the desired melody.
How to Set Incoming Call Ring Volum
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Continuously press
SEL button until “RING” displays.
3. Rotate
VOL knob to the desired level.
How to Set Conversation Volume
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Continuously press
SEL button until “TEL” displays.
3. Rotate
VOL knob to the desired level.
Disconnect Paired Devices
You can disconnect to an already paired Bluetooth device from your car stereo.
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Continuously press
SEL button until “DISCONN” displays.
3. Press and hold
SEL button again to disconnect.
RESET
A reset button is placed on the front housing.
The reset button is to be activated for the following reason:
Initial installation of the unit after all wiring is complete.
No function buttons operate.
Error symbol on the display.
RESET