11
HOW TO USE BLUETOOTH IN YOUR CAR AUDIO
How to Perform Pairing
Before dialling out from the car stereo, PAIRING must rst be performed.
Pairing is a procedure used to connect 2 Bluetooth devices together.
1. Press and hold
SEL button for 2 seconds.
2. Press
SEL button repeatedly until “PAIRING” displays.
3. Press and hold
SEL button to engage pairing mode. “PAIRING” blinks on the display.
4. Turn on the Bluetooth feature of your mobile phone. Perform “Add Bluetooth device” from your mobile
phone. The mobile will search for any Bluetooth devices within the range. Select “CAR BLUETOOTH”
and enter Passkey: “0000” to connect to the car audio.
5. The LCD will display
“PAIRED” when successful.
Note:
• If “DISCONN” shows instead of “PAIRING”, it means the head unit currently is paired with another
device. Press and hold SEL button to disconnect the connection and perform steps above again.
•
“CAR BLUETOOTH” is the Bluetooth device name of the car stereo.
• Refer to your cellular user manual for the proper procedures of pairing Bluetooth devices.
Switching to Telephone Mode
1. During any operation mode, press and hold “*” to activate TELEPHONE mode.
Press and hold it again to return to previous mode.
Making Calls Using the Remote Control
Before making calls directly from the remote control ensure that the devices are properly paired and con-
nected.
1. Press and hold “*” on remote control. Unit will switch to phone mode.
2. Enter the phone number via the remote control keypad and press
button to dial out.
Press
bbutton to make corrections when entering numbers.
3. Press
bbutton to end call.
Audio Streaming
If your phone is “A2DP” format compatible, then you can play music in your mobile and the sound will
be transferred to the vehicle’s sound system.
1. Mobile phone and the head unit must be properly paired and connected.
2. Play the music through your mobile music player software.
3. Continuously press
MODE until “BT-PLAY” appears in the display. The sound will transfer to the head
unit.
Answering / Hanging Up
To answer a call, press the button on the remote control.
Once you have nished your conversation, press the button to hang up.
Calls (Outgoing, Incoming)
The unit stores all the incoming and outgoing calls. Use this feature to check the numbers and make calls.
“OUT NUM” – outgoing calls made through the remote control.
1. Press and hold (*) then press and hold
SEL button for 2 seconds. “OUT NUM” displays.
2. Press and hold
SEL button again.
3. Rotate volume knob to search for entries and press
to call.
“IN NUM” – incoming calls received.
1. Press and hold (*) then press and hold
SEL button for 2 seconds.
2. Press
SEL button repeatedly until “IN NUM” displays.
3. Press and hold
SEL button again.
4. Rotate volume knob to search for entries and press
to call.
To Next Page
Loading...
