Axis Q6032-E PTZ - Reset to Factory Default

PRODUCT REVIEW GUIDE  AXIS Q6032-E Network Camera
Axis Communications Last updated: September, 2009
10
6.5 Reset to factory default
If you for any reason contact with the camera is lost, you can reset it to factory default settings:
1. Remove the dome cover from the camera unit; this will automatically disconnect power
from the camera.
2. Press and hold the Control button and the Power button.
3. Keep the both buttons pressed until the Status indicator LED flashes amber (this may
take up to 15 seconds).
4. Release the Control button. When the Status indicator LED displays green (which can
take up to 1 minute) the process is complete and the camera has been reset. The Status
indicator LED will display green for 10 seconds only. After that it will be unlit.
5. Release the Power button and replace the dome cover, this will automatically reconnect
power to the camera.
6. Re-assign the IP address.
Status indicator LED
Control button
Power button
(for Factory Default only)
Caution!
Heater
may be hot