Axminster MB9020 - Maintenance

To Next Page

To Previous Page

WHITE

AXMINSTER

Changing & Sharpening the Knifes...

• Clean all parts and knife slots in the cutterblock.

• Insert the chipbreaker/wedge device with new or sharpened knife and align laterally with the

cutterblock.

• Put the blade setting tool on the top surface of the adjustable infeed table as shown in

fig 24 below. Be sure the face (A) of the blade setting tool is located on the top surface of the

adjustable infeed table, the face (B) to the end face of the infeed table, and the face (C) on the

edge of knife. (See fig 25)

• Press the blade setting tool with one hand, and tighten the clamping bolts (20) by turning

counterclockwise with the 8mm spanner provided. (See fig 26)

• Finally push the cutterblock guard (9) back in position to cover the cutterblock and replace

the guide fence. (See fig 27)

Maintenence...

DISCONNECT THE PLANER THICKNESSER FROM THE MAINS SUPPLY

The planer-thicknesser MB9020 is designed with a low maintenance requirement. The bearings

are greased for life. After approximately 10 hours of operation we recommend to lubricate the

following parts: (Note we recommend using "Rocol Dry PTFE part no: 810135").

• Bearings of the feed-in and feed-out rollers.

• Bearings of pulley and gear wheel of the belt. Treat threaded spindles for the height

adjustment of the thicknessing table with dry lubrication only!

Fig 24

Fig 25

Fig 26

Fig 27