05
WHITE
AXMINSTER
W
General Safety Instructions...
www.axminster.co.uk
8. DON'T FORCE TOOL. It will do the job better and safer at the rate for which it was designed.
9. USE RIGHT TOOL. Dont force tool or attachment to do a job for which it was not designed;
for example, don’t use circular saw for cutting tree limbs or logs.
10. WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings, bracelets,
or other jewelry which may get caught in moving parts. Non-slip footwear is recommended.
Wear protective hair covering to contain long hair.
11. ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty
everyday, eyeglasses only have impact resistant lenses, they are NOT safety glasses.
12. SECURE WORK. Use clamps or a vice to hold work when practical. It's safer than using
your hand and it frees both hands to operate tool.
13. DON'T OVERREACH. Keep proper footing and balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest
performance. Follow instructions for lubricating and changing accessories.
15. DISCONNECT TOOL before servicing; when changing accessories such as blades, bits,
cutters, and the like.
16. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in OFF position
before plugging in or inserting battery if applicable.
17. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended
accessories. The use of improper accessories may cause risk of injury to persons.
18. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the cutting
tool is accidentally contacted.
19. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate property and perform its
intended function - check for alignment of moving parts, binding of moving parts, its operation.
A guard or other part that is damaged should be properly repaired or replaced.
20. DIRECTION OF FEED. Feed work into a blade or cutter against the direction of rotation of
the blade or cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN power off. Dont leave tool until it
comes to a complete stop.
22. DON'T ABUSE CORD. Never carry tool by cord or pull it to disconnect from socket. Keep
cord from heat, oil and
sharp edges.
23. USE SUITABLE VOLTAGE. Before connecting the machine to a power source, be sure that
the voltage supplied is the same as that specified on the nameplate of the machine.
To Next Page
Loading...