Chapter 3: Recording with the Axon Body 2 Camera 7
Axon Body 2 Camera User Manual
With default settings, the system does not capture audio in BUFFERING mode, so anything
recorded in that mode will be video-only. BUFFERING mode starts only after the Axon Body 2
camera is turned on. The system does not record when the camera is turned o.
Notes:
• An agency can turn o the BUFFERING mode. If your agency has deactivated the BUFFERING
mode, your Axon system will operate the same way as described in this manual, but the
camera will not record anything until you double-press the EVENT button.
• An agency can extend the BUFFERING mode’s duration to 2 minutes total (00:02:00).
• An agency can configure the BUFFERING mode so it records audio as well as video.
EVENT Mode (Starting Recording)
1 When you need to record, quickly double-press the EVENT button on the camera.
The system now records audio as well as video. The “buered” video directly preceding the
event will be saved and attached to the event recording. Remember, with default settings,
the buered video will not contain audio. The moment you double-press the EVENT
button, both video and audio will be recorded from the camera and GPS coordinates (if
the system is paired to a GPS-capable smart phone) will be recorded. This will continue
throughout the duration of the recording until you end the recording.
The camera provides you with indications that it is recording in EVENT mode:
• At the start of an event and every 2 minutes during an event, the system will beep
twice.
• The Operation LED on top of the camera will blink red.
2 To stop recording and return to BUFFERING mode, press and hold the EVENT button for
approximately 3 seconds. The system will beep once (with a long tone).
3 To end a recording and turn o the system, move the on/o switch to the o position.
When you end a recording with the on/o switch you will not go into BUFFERING mode;
instead the system will turn o completely.
Note: An event not recorded by the camera cannot be played back or downloaded to your
computer.
Muting Audio Recording
If your organization’s administrator has configured your Axon system to do so, you can use
the Function button to disable audio recording during an event. This feature may be useful in
sensitive situations.
1 Press and hold the Function button for 3 seconds to mute the audio capture.
The Function LED will blink blue while the camera is muted.
2 Press and hold the Function button another 3 seconds to re-enable the audio recording.
To Next Page
Loading...
Need help?
General
