EasyManuals Logo

Axon AX1001 User Manual

Axon AX1001
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
17
Chapter 6: Care and Maintenance
Cleaning the Axon Body 2 Camera
Use a soft, damp cloth to clean the surface of the Axon Body 2 camera. Do not use harsh cleaners
or solvents.
Do not immerse the Axon Body 2 camera in water or cleaning solutions.
If the Axon Body 2 camera lens becomes dirty, use a lens blower brush to clean it and then wipe
it with a soft cloth if necessary.
You may moisten the cloth with isopropyl alcohol.
Do not use ammonia-based or similar type window cleaners on the camera lens.
Do not place the lens under running water or apply jets of water to the camera lens.
Charging the Battery
A fully charged camera battery should provide enough power for approximately 12 hours of normal
operation. Recharging a battery after a 12-hour use can take up to 9 hours if you are recharging
your Axon Body 2 camera from Axon Dock. Recharging could take considerably longer if you are
recharging from a computer.
If the battery depletes significantly during use, you will hear 4 quick tones and vibrations, if
enabled, repeating every 20 seconds. This message indicates that less than approximately 20
percent of the battery capacity remains.
Always recharge a depleted battery as soon as reasonably possible. You can use an Axon Dock
or computer to charge the battery. Using a non-Axon approved wall charger may degrade device
performance and will void the warranty.
If the Axon Body 2 camera is to be stored for a long time, the Battery LED should be yellow when
you put the camera in storage. After an Axon Body 2 camera has been stored 6 months, the
camera should be run until the battery is depleted and then the battery should be recharged.
Camera Internal Clock
Axon Body 2 cameras should be regularly placed in an Axon Dock or connected to Evidence Sync
to update the camera’s internal clock.
Camera Storage
Axon on-ocer cameras should not be stored in environments where the temperature is likely to
exceed 95 °F (35 °C) (such as under direct sunlight, near heaters, or in a vehicle in extremely hot
weather) or exposed to temperatures below −4 °F (−20 °C).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axon AX1001 and is the answer not in the manual?

Axon AX1001 Specifications

General IconGeneral
BrandAxon
ModelAX1001
CategoryDigital Camera
LanguageEnglish

Related product manuals