Axon Fleet 3 Camera System User Manual
Axon Enterprise, Inc. Page 10 of 19
Recording with the Axon Fleet 3 System
The Axon Fleet 3 Dual-View and Interior cameras can operate independently of each other.
Operating Modes
The Axon Fleet 3 camera system has 2 operating modes:
1. BUFFERING (turning on the camera and starting pre-event buffering)
2. EVENT (event recording)
BUFFERING Mode (Turning on the Camera)
The cameras will always be powered on while the Fleet Hub senses IGNITION ON
With the camera turned on, the system is in the BUFFERING mode. When BUFFERING begins:
• The Primary and Secondary LED on the back of the Dual-View Camera will be solid
green.
• The camera captures video but does not record to permanent memory while in
BUFFERING mode. The exception is when an agency has the Video Recall feature
enabled.
Note: Video captured with the Video Recall feature is has a lower resolution and
there is no audio.
• Buffered video duration is 30 seconds by default (00:00:30).
When EVENT mode is activated, the buffered video captured directly before the event is
saved and attached to the event in permanent memory. This feature is intended to
capture the video of an incident just before your activation of EVENT mode.
With default settings, the system does not capture audio in BUFFERING mode, so anything recorded
in that mode will be video-only. BUFFERING mode starts only after the Axon Fleet system is turned
on via power on of the Fleet Hub.
Notes:
• An agency can disable pre-event BUFFERING.
• An agency can configure the BUFFERING mode so it records audio as well as video.
To Next Page
Loading...
