Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Insert the supplied keys into the slots as shown.
• Connect wiring harness as shown on page 5. Consult a qualified technician if you are
unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold
separately).
• Reconnect negative battery terminal, and test for correct operation.
• Snap trim ring into place (if required).
Preparation
TRIM PLATE
UNIT
KEY
SLEEVE
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
To Next Page
Loading...
