CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
XSVI-6523-NAV
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 8/25/17 INSTXSVI-6523-NAV
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell
caps, etc.)
TABLE OF CONTENTS
Connections to be made .......................................2
Installing the XSVI-6523-NAV................................3
Initializing the XSVI-6523-NAV .............................3
Chrysler Data Interface 2013-up*
APPLICATIONS
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Can be used in both amplified and non-amplified models
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Retains the factory backup camera (if displayed through the OE radio)
• Retains the 3.5mm AUX-IN jack
• Retains balance and fade
• Micro “B” USB updatable
CHRYSLER
200 LX 2015-2016
DODGE
Dart (small screen option) 2013-2016
JEEP
Cherokee Sport 2014-up
RAM
1500/2500/3500 (small screen option) 2013-up
Chassis Cab 3500/4500/5500
(small screen option) 2013-up
• XSVI-6523-NAV interface
• XSVI-6523-NAV harness
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
To Next Page
Need help?
General
