CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
AX-ADFD01
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 6/26/18 INSTAX-ADFD01
INTERFACE FEATURES
INTRODUCTION
TOOLS REQUIRED
• Crimping tool and connectors or solder gun,
solder, and heat shrink • Wire cutter • Zip ties
• Small flat-blade screwdriver • Tape
TABLE OF CONTENTS
Connections to be made
For models
without
a Sony/THX amplifier .....2-3
For models
with
a Sony/THX amplifier .........4-5
Installing & programming the AX-ADFD01
AX-ADBOX1 ...........................................................5
AX-ADBOX2 ..........................................................6
Adjusting the AX-ADFD01 ......................................7
Extra features .........................................................7
Ford Data Interface 2007-up*
APPLICATIONS
See inside front cover
• Provides accessory power (12-volt 10-amp)
• Maintains the retained accessory power (R.A.P.) feature
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains rear seat entertainment (R.S.E.)
• Retains satellite radio
• Retains SYNC
• Retains the factory AUX-IN jack
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Can be used in both non-amplified and amplified models
(including Sony/THX)
• Retains balance and fade†
• Micro “B” USB updatable
The AX-ADFD01 harness is designed for, and must be used with, the
AX-ADBOX1 or AX-ADBOX2 interface (sold separately). Please refer to the
AX-ADBOX1 or AX-ADBOX2 for the 16-pin connector with stripped leads.
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
† Excluding Sony/THX
INTERFACE COMPONENTS
• AX-ADFD01 harness
To Next Page
Need help?
General
