AXDIS-CH13
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 7/28/20 INSTAXDIS-CH13
Product Info
INTERFACE FEATURES
INTERFACE COMPONENTS
TABLE OF CONTENTS
Connections ........................................................ 3-5
- For models without an amplifier .......................3
- For models with an amplifier ............................4
- 3.5mm jack steering wheel control retention ..5
Installation .............................................................5
Programming .........................................................6
Adjustments ...........................................................6
Steering wheel control settings ....................... 7-9
- L.E.D. feedback ....................................................7
- Changing radio type ...........................................7
- Remapping the steering wheel control buttons ... 8
- Dual assignment instructions (long button press) ...9
Troubleshooting ................................................... 10
Chrysler Data Interface with SWC 2004-Up
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
• Retains safety chimes (LD-BX-CH4 applications)
• Can be used in both amplified and non-amplified models
• Retains balance and fade (non-amplified models only)
• Retains Blind Spot Detection (if equipped)
• Includes antenna adapters for both generations of vehicles
• Micro-B USB updatable
• AXDIS-CH13 interface
• LD-BX-CH3 harness
• LD-BX-CH4 harness
• 16-pin harness with stripped leads
• 4-pin harness with stripped leads
• Female 3.5mm connector with stripped lead
• Antenna adapters (2)
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
APPLICATIONS
See inside front cover
To Next Page
Need help?
General
