Axxess AXDIS-TY1 User Manual

AXDIS-TY1
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2024 METRA ELECTRONICS CORPORATION REV. 4/22/24 INSTAXDIS-TY1
ATTENTION: With the key out of the ignition, disconnect
the negative battery terminal before installing this product.
Ensure that all installation connections, especially the air
bag indicator lights, are plugged in before reconnecting the
battery or cycling the ignition to test this product.
NOTE: Refer also to the instructions included with the
aftermarket accessory before installing this device.
INTERFACE FEATURES
INTERFACE COMPONENTS
• Wire cutter
• Crimp tool
• Solder gun
• Tape
• Small flat-blade screwdriver
• Connectors (example: butt-
connectors, bell caps, etc.)
TABLE OF CONTENTS
Applications ...........................................................2
Connections:
Non-Amplified Models: LD-TYNOAMP .................3
Amplified Models: LD-BX-TY2 .............................4
3.5mm Jack Steering Wheel Control Retention ....5
Installing the AXDIS-TY1 ........................................5
Programming the AXDIS-TY1 ................................6
Audio Level Adjustment .......................................6
Steering Wheel Control Settings .....................7-10
LED Feedback .......................................................7
Changing Radio Type ..........................................8
Remapping the SWC Buttons .........................8-9
Dual Assignment Instructions ........................... 10
Troubleshooting.................................................... 11
Lexus/Toyota Interface with SWC 2002-2015
• AXDIS-TY1 interface
• AXDIS-TY1 harnesses (LD-TYNOAMP, LD-BX-TY2 AND LD-2NAVAMP)
• Female 3.5mm connector with stripped leads
Visit AxxessInterfaces.com for more detailed information
about the product and up-to-date vehicle specific applications.
• Designed for both amplified and non-amplified models
• Provides accessory power (12-volt 10-amp)
• Retains audio controls on the steering wheel
• Provides NAV outputs (parking brake, reverse)
• Retains the factory AUX-IN jack
• Retains balance on amplified models
(non-amplifed models will retain balance and fade)
• Micro-B USB updatable
APPLICATIONS (See Page 2)
Product Info
TOOLS REQUIRED

Axxess AXDIS-TY1 Specifications

General

Steering Wheel Control	Yes
Navigation Outputs	Yes
Amplifier Turn-On	Yes
Reverse Output	Yes
Illumination Output	Yes
Compatibility	Toyota
Function	Data Interface
Features	Retains factory features
Remote Control	No

Summary

Applications

Non-Amplified Model Connections

Amplified Model Connections

Connections (Continued)

3.5mm Jack Steering Wheel Control Retention

Connects the 3.5mm jack to retain SWC. Specific wiring for different radios is detailed.

Installing the AXDIS-TY1

Installation With Key Off

Installation steps with the ignition off. Includes safety precautions before connecting.

Programming the AXDIS-TY1

Audio Level Adjustment

Steering Wheel Control Settings: LED Feedback

SWC Settings: Radio Type and Remapping

Changing Radio Type

Manually set radio type if auto-detect fails. Uses Volume buttons for selection.

Remapping SWC Buttons

Customize button functions. Allows reassigning steering wheel control button actions.

SWC Settings: Button Assignment

Dual Assignment Instructions

Troubleshooting

Resetting the AXDIS-TY1 Interface

Procedure to reset the interface using the blue reset button. Refer to programming after reset.