11
AB-7333
<Installation on a DIN Rail>
(1) Pull down the two DIN holders on the bottom of the
device.
(2) Hook the upper part of the DIN holder to the DIN rail
and check that it is hooked securely.
(3) Push up the two DIN holders on the bottom of the
device.
(4) Check that the four DIN holders on the top and
bottom of the device are secured on the DIN rail.
Check that the device is steady.
(5) Secure both ends with the DIN rail clamps (Model
83104567- 001).
After installation, keep the connectors that come
with the device because they will be used for wiring
connection.
Pull out
Hook
Push up
<Direct Installation with Screws>
Install the product on the wall or panel wall using four M4
L=8 screws or four studs with female threads.
(1) Make four screw holes in the installation locations.
(2) Pull up the two DIN holders at the top of the device
and then pull down the two DIN holders on the
bottom.
(3) Use the four holes for the DIN holder to secure the
device with the M4 screws.
Check that the device is steady.
150 mm
160 mm
Pull out
Pull up
Secure with
an M4 screw
To Next Page
Loading...
